Zebra Technologies 11680100201 Benutzerhandbuch

Standard Control Panel Parameters

1/7/10

Xi4™/RXi4™ User Guide

P1009874-002

 shows parameters in the order in which they are displayed when you press 

NEXT/SAVE

 after entering Setup mode. For parameters that do not appear in this table, see 

.

Your label preparation software or the printer driver may override adjustments made 

through the control panel. Refer to the software or driver documentation for more 
information.

Adjust Print Darkness
Darkness (burn duration) settings depend on a variety of factors, including 
ribbon type, media type, and the condition of the printhead. You may adjust 
the darkness for consistent high-quality printing.

Set the darkness to the lowest setting that provides 

good print quality. If the darkness is set too high, the ink may 
smear, the ribbon may burn through, or the printhead may wear 
prematurely.

If printing is too light or if there are voids in printed areas, increase the 
darkness. If printing is too dark or if there is spreading or bleeding of 
printed areas, decrease the darkness.

 can be used to determine the best darkness 

setting. You may want to adjust darkness while performing the 

. Because the darkness setting takes effect immediately, 

you can see the results on labels that are currently printing. Darkness 
settings also may be changed by the driver or software settings.

Default Value: +4.0

Range: 0 to +30.0

Press 

PLUS (+) 

to increase darkness.

Press 

MINUS (-)

 to decrease darkness.

Adjust Print Speed
Adjusts the speed for printing a label (given in inches per second). Slower 
print speeds typically yield better print quality. Print speed changes take 
effect upon exiting Setup mode.

Default Value: 2 IPS

Range: Varies by printer type (see 

 for values by model)

Press 

PLUS (+) 

to increase the value.

Press 

MINUS (-)

 to decrease the value.