Epson WF-7510 Benutzerhandbuch

Seite von 88
26
Replacing Ink Cartridges
4. Squeeze the tab on the cartridge and lift it up. Dispose of it 
carefully. Do not take the used cartridge apart or try to refill 
it.
Warning: If ink gets on your hands, wash them thoroughly 
with soap and water. If ink gets into your eyes, flush them 
immediately with water. Keep ink cartridges out of the 
reach of children and don’t drink the ink.
5. Before you open the new cartridge package, shake it gently four or five times. Then 
remove it from the package.
6. Remove the yellow tape from the bottom of the ink 
cartridge.
Caution: Do not remove any other labels or seals, or 
ink will leak. Do not touch the green chip on the front 
of the cartridge. This can damage the ink cartridge.
7. Insert the new ink cartridge into the holder and push it 
down until it clicks into place.
8. Once you replace all the cartridges that need replacing, close the cartridge cover and 
push it down until it clicks into place.
9. Close the scanner to begin charging the ink. This takes about 2 1/2 minutes. When 
you see a completion message on the LCD screen, ink charging is finished.
Caution: Never turn off the product while ink is charging or you’ll waste ink. If you see 
an ink replacement message on the LCD screen, press OK and press down all the 
cartridges securely. Then press OK again. If you remove a low or expended ink 
cartridge, you cannot reinstall and use the cartridge.
Masuo_Masuo-P2_QG.book  Page 26   Thursday, June 30, 2011  3:53 PM