Konica Minolta 250 Benutzerhandbuch

Seite von 468
2
Setup
2-46
200/250/350
Se
tu
p
Ch
apte
r 2
LDAP Server Setting
LDAP server settings can be specified for the following.
Item
Description
LDAP Server Name
Enter the LDAP server name. Up to 16 characters can be en-
tered.
Server Address
Enter the IP address or host name of the LDAP server. Up to 64 
characters can be entered.
Search Base
Specify the location on the LDAP server where searches are to 
be started.
Up to 255 alphanumeric characters can be entered, excluding 
^.
Authentication Setting
Specify the authentication settings.
General Settings: Select the LDAP authentication method.
Login name: Enter if “General Settings” is set to “Anonymous”. 
Up to 64 alphanumeric characters can be entered, excluding ^.
Password: Enter if “General Settings” is set to “Anonymous”. 
Up to 32 alphanumeric characters can be entered, excluding ^.
Domain Name: Enter if “General Settings” is set to “GSS-SPNE-
GO”. Up to 64 alphanumeric characters can be entered, exclud-
ing ^.
Maximum number of search
Specify the maximum number of hits to be received in an LDAP 
search between 5 and 100.
Connection time out
Specify a search timeout between 5 and 300 seconds.
SSL/TLS
Select whether to perform encryption of the send data using 
SSL/TLS.
Port Number
Enter a number between 1 and 65535 for the port used to com-
municate with the LDAP server.
Initialize Setting
Clears all of the settings that were entered. After the settings are 
cleared, check the message, and then touch [Enter].
Check Connection
Check the connection to the LDAP server, using the entered 
settings.