iiyama E2208HDD Benutzerhandbuch

  Ensure that both the computer and the monitor are switched off.

 Connect the computer to the monitor with the signal cable.
 Connect the monitor to the audio equipment with the Audio Cable for computer when using the 

audio features.

 Connect the Power Cable to the monitor fi rst and then to the power supply.

  Power of the monitor and the computer is turned on.

 The signal cables used for connecting the computer and monitor may vary with the type of 

computer used. An incorrect connection may cause serious damage to both the monitor and 

the computer. The cable supplied with the monitor is for a standard 15 pin D-Sub connector. If 

a special cable is required please contact your local iiyama dealer or regional iiyama offi ce.

 

 For connection to Macintosh computers, contact your local iiyama dealer or regional iiyama 

offi ce for a suitable adaptor.

 

 Make sure you tighten the fi nger screws at each end of the signal cable.

Power Cable

(Accessory)

Audio Cable* (Accessory)

Computer

D-Sub Signal Cable

(Accessory)

DVI-D Cable (Accessory)

[Example of Connection]

<Back>



 

Pull out the hook.

 

Hold the both sides of the hook, and remove one 

tab at a time.



 

Collect cables at the back of the stand.

 

Hold the both sides of the hook, and insert one 

tab at a time into the holes.

*

   

Available for ProLite E2208HDS only.

7     BEFORE YOU OPERATE THE MONITOR