Sharp TINSE1166MPZZ Benutzerhandbuch

12

E

Caution

•  Turn on the monitor first before turning on the PC or

playback device.

Caution

•  The main power must be turned on/off with the main power

switch. Do not connect/disconnect the power cord or turn
the breaker on/off while the main power switch is on.

•  When switching the main power switch or the POWER

button off and back on, always wait for at least 5 seconds.

Press the POWER button on the remote control unit or the
monitor itself to turn the power ON/OFF.
When the main power switch is off, the monitor cannot be

turned on using the POWER button on the remote control unit.

Green lighting

Power on

Orange lighting

Power off (Standby mode)

Green flashing

Input signal waiting mode

Caution

•  When switching the main power switch or the POWER

button off and back on, always wait for at least 5 seconds.
A short interval may result in a malfunction.

TIPS

•  If the monitor is in the input signal standby mode and you

press the POWER button on the remote control unit, the
monitor enters standby mode.

•  Setting the SCHEDULE flashes the power LED alternately

in red and orange in standby mode.

•  If you change the remote control mode to ALL MONITORS,

power can be turned ON/OFF for all slave monitors 
connected with RS-232 cable. (For operation of the master
monitor, use the buttons on the monitor itself.)

nOperation mode

When the monitor is turned on for the first time after being
shipped from the factory, the operation mode setting screen 

will be displayed. Set it to MODE1 or MODE2.

MODE1 ....Limits the maximum brightness to approx 65% of MODE2. 

OFF IF NO OPERATION is set to ON, and STANDBY

MODE is set to LOW POWER2. (These settings can not
be changed.) 
If there is no operation for 4 hours or more, the monitor  
automatically enters standby mode. Power consumption 

in standby mode is also minimized.

MODE2 ....Will perform standard operation. 

OFF IF NO OPERATION is set to OFF, and 

STANDBY MODE is set to STANDARD. These
settings can be changed.

Even after being set, changes can be made using 

OPERATION MODE, located in the main menu of the monitor.
(See Operation Guide.)

nDate/time setting

•  If the time has yet to be set when the monitor is first turned on,

the date/time setting screen appears. Set the date and time.

/

/ 

OK···[MENU] 

:

   

:

1.  Press 

 , 

 , 

 or 

 to select the date and 

time, and press 

 or 

 to change the numerical 

values. 

2.  Select SET and then press 

MENU

 .

•  Be sure to set the date and time.

•  The date/time setting screen will close automatically if no 

operation is performed for about 15 seconds. The date

and time can be set using DATE/TIME SETTING from the
OPTION menu when the date/time setting screen disappears.

TIPS

•

Set the date in “Year/Month/Day” order.

•

Set the time on a 24-hour basis.

•

The clock is maintained by the internal battery.

•

If you already set the time but the date/time setting 
screen appears when the power is turned on, the 
internal battery may be exhausted. Please contact 
your local Sharp servicing dealer or service center for 
assistance with battery replacement.

•

Estimated service life of the internal battery: About 5
years (depending on monitor operation)

•

As the first battery was inserted at the factory, it may be
exhausted prior to the expected continuous operation life.

Power on/power off operations can be disabled in order to protect 
the monitor from an accidental power off. Set the ADJUSTMENT

LOCK in FUNCTION menu to “2”. (See Operation guide.)