3M M2256PW Benutzerhandbuch

10 

 

3M™ Multi-touch Display M2256PW User Guide 

3M Touch Systems, Inc. Proprietary Information – 37531 Rev D

This chapter describes how to set up your 3M Touch Systems M2256PW Multi-touch 
Display. You need to complete the following tasks: 
• Unpack the components 

• Connect the video, touch display cables, and power cables 

• Power on the display and test your setup 

• If you are not running Windows 7 (or Tablet PC), install MT7 software from the 

enclosed CD. Note that this will not make multitouch happen -- it is up to your 
application to enable multitouch. 

The M2256PW Multi-touch Display requires a personal computer (PC). The 
requirements for your PC are as follows: 
• Your PC must have an available USB or RS-232 serial communication (COM) port. 

You connect the touch sensor cable to this port. 

• Your PC must have a video card and video driver already installed for the display. If 

you need to install a video card or a video driver, refer to your computer 
documentation for instructions. 

When choosing your workspace, select a sturdy, level surface. Also, make sure you can 
easily access the back of the touch display and the computer. Easy access helps ensure a 
smooth setup of the touch display. 

Note:  Before setting up your M2256PW Multi-touch Display, refer to the “Important 
Safety Information” section at the beginning of this document.