Pioneer PRO-FHD1 Benutzerhandbuch
18
En
Preparation
06
Connecting the power cord
CAUTION
• Use only the supplied power cord.
• Be sure to use the specified power supply voltage;
• Be sure to use the specified power supply voltage;
neglecting this can result in fire or electric shock.
• For the Plasma Display, a three-core power cord
with a ground terminal is used for efficient
protection. Always connect the power cord to a
three-pronged outlet and make sure that the cord
is properly grounded.
protection. Always connect the power cord to a
three-pronged outlet and make sure that the cord
is properly grounded.
NOTE
• Always turn off the power of the Plasma Display when
connecting or disconnecting power cords.
• When not using this unit for extended periods, disconnect
the power cord from its outlet.
Connecting the speakers
This unit is equipped with speaker output terminals. Consult
the accompanying illustration when connecting your own
speakers.
the accompanying illustration when connecting your own
speakers.
NOTE
• When connecting speakers, be sure to connect the
speaker’s positive (+) and negative (–) terminals to the same
terminals on this unit. Proper sound will not be produced if
the (+) and (–) polarities are not connected correctly.
terminals on this unit. Proper sound will not be produced if
the (+) and (–) polarities are not connected correctly.
• This unit supports the use of speakers with 8
Ω
to 16
Ω
impedance.
AC IN
L
SPEAKER
8
8
Ω
~16
Ω
+ –
Power cord
Noise filter
Partially eliminates noise caused by the power source.
Partially eliminates noise caused by the power source.
12 mm
Twist exposed wire
strands together.
strands together.
Push tab to the open
position, and insert the
wire. Then, close tab firmly
to secure the wire in place.
position, and insert the
wire. Then, close tab firmly
to secure the wire in place.