Seagate ST9550AG Benutzerhandbuch
![Seagate](https://files.manualsbrain.com/attachments/b8a65e13882738a617b4fb1dec35c49349976167/common/fit/150/50/2b4b03599a6f710d30699589ed58ececb8b6db2f0c51d2afc623a22705ee/brand_logo.png)
the full capacity of the drive, and a user-defined drive type is
not available, use a third-party partitioning utility.
not available, use a third-party partitioning utility.
•
Run FDISK again and make the partitions smaller. If you are
using a version of DOS prior to Version 4.0, make the drive
partitions smaller than 32 Mbytes.
using a version of DOS prior to Version 4.0, make the drive
partitions smaller than 32 Mbytes.
At startup, the messages, “Disk Boot Failure,” “Non-System
Disk,” or “No ROM Basic - SYSTEM HALTED,” appear.
Disk,” or “No ROM Basic - SYSTEM HALTED,” appear.
•
Run the FDISK program and make sure the primary partition
is marked active.
is marked active.
•
Check all cables.
•
Check your DOS version.
•
Reinstall the DOS system files onto the hard disc using the
SYS command (see your DOS manual).
SYS command (see your DOS manual).
•
Check for viruses.
During operation, the system error message, “Drive not
Ready,” appears.
Ready,” appears.
•
Check all cables.
•
Check the power supply.
•
Reboot the computer and make sure the drive spins up.
16
ST9655 Family Installation Guide, Rev. A