Seagate ST313620A Benutzerhandbuch
4
Barracuda ATA Family Installation Guide, Rev. A
Master/slave jumpers
If you already have one hard drive in your computer and you are
installing a second drive, you must configure one drive as a mas-
ter and the other as a slave.
installing a second drive, you must configure one drive as a mas-
ter and the other as a slave.
Note. If you need to change the jumpers on your existing hard
drive, see the Disk Manager online manual, look on the
drive label, or contact the drive manufacturer.
drive label, or contact the drive manufacturer.
Installing a master or one drive only:
•
The drive is shipped configured for a master or single-drive
installation with a jumper set on pins 7 and 8.
installation with a jumper set on pins 7 and 8.
Note. The master drive usually defaults to being the “boot” drive
(drive C), from which the computer loads system soft-
ware when it first starts up.
ware when it first starts up.
Installing a slave drive:
•
If you are installing your drive as the second drive on the
cable, remove all the jumpers.
cable, remove all the jumpers.