Seagate ST310220A Benutzerhandbuch
2
Barracuda ATA Family Installation Guide, Rev. A
What you need
•
Straight-edge and Phillips screwdrivers
•
Four 6-32 UNC drive mounting screws
•
A standard 40-pin ATA interface cable,
or an 80-conductor
cable to run Ultra ATA 66 (max length: 18 inches)
•
An unused drive power cable for your new drive
Ultra ATA/66 Requirements
The drive can support transfer rates up to 66 Mbytes per second
in Ultra ATA/66 mode. For your drive to run in this mode you
need the following:
in Ultra ATA/66 mode. For your drive to run in this mode you
need the following:
•
A computer that supports UDMA modes 3 and 4
•
A 40-pin 80-conductor cable (maximum length 18 inches)
•
A software utility to activate Ultra ATA/66. Seagate provides a
utility called UTA66.exe that is included on your CD, or you can
download it from our Web site at www.Seagate.com.
utility called UTA66.exe that is included on your CD, or you can
download it from our Web site at www.Seagate.com.
•
The Windows 98 operating system
Before you begin
•
Make sure your computer is turned off before you open the
case.
case.
•
Read the handling precautions at the right and inspect the
drive to make sure that it is not damaged.
drive to make sure that it is not damaged.
•
Save your foam-lined Seagate
disc drive box. This box has
been approved by Seagate for shipping a Seagate disc drive.
Using any other container or packing material voids your drive
warranty.
Using any other container or packing material voids your drive
warranty.