Hitachi HUS103073FL3600 Benutzerhandbuch

 

Drawing No. Sheet No.  Revision  ６

K6610091

28/43 2005/2/23

 

 

8.4 Other Precautions 

8.4.1 Do not loosen the screws or disassemble the drive. 
8.4.2 Do not remove the PCB from the drive or swap the PCB with other drives. 
8.4.3 Do not solder the wire or other parts on the PCB, or reconstruct the PCB. 
8.4.4 Do not remove the sealing tape or label on the HDA. 
8.4.5 Turn off the power before removing or installing the DC power cable and   

  SCSI interface cable. Turn off the power before removing or installing the 
jumper. 

8.4.6 Remove the DC power and SCSI interface connectors carefully in order 

  not to damage the contact pins and the connector housing. 

8.4.7 Do not move the drive when the disks are rotating or while the power is 

  on or for 20 seconds after the power has been turned off. 

 
 

 

9.1  The HDD itself is maintenance free and there are no individual parts that require 

maintenance. If maintenance for the HDD is required, the entire product will need 

to be serviced, since it can not be divided into parts. System maintenance should 

be executed by the host system. 

 

9.2  The supplier will repair or exchange the product due to malfunction covered 

under the warranty. The warranty and service will be agreed upon between the 

customer and the supplier. The supplier is neither liable or obligated to service 

any product due to carelessness or mishandling of product. 

 

9.3  Even if the drive fault occurs during the In-warranty period, the supplier will repair 

or replace the drive but will not be liable for any expenses of disk drive 

installation or detachment to or from system. (This includes data back up, data 

copy, etc.)