Fujitsu MBA3300RC Benutzerhandbuch
Command Specifications
216
C141-C013
4.2.3 WRITE (0A)
Bit
Byte
7
6
5
4
3
2
1
0
0
X'0A'
1
0
0
0
Logical Block Address (MSB)
2
Logical Block Address
3
Logical Block Address (LSB)
4
Transfer Block Count
5
0
0
0
0
0
0
0
0
This command transfers the number of blocks of data specified in the "Transfer
block count" field from the INIT and writes them in continuous logical data
blocks with the logical data block on the disk media specified in the "Logical
block address" field in the CDB as the top.
block count" field from the INIT and writes them in continuous logical data
blocks with the logical data block on the disk media specified in the "Logical
block address" field in the CDB as the top.
The transfer block count can be specified up to a maximum of 256 logical data
blocks. When zero is specified in the "Transfer block count" field in byte 4 of the
CDB, it specifies transfer of 256 logical data blocks and when a value other than
zero is specified, it specifies the number of logical data blocks that should be
transferred.
blocks. When zero is specified in the "Transfer block count" field in byte 4 of the
CDB, it specifies transfer of 256 logical data blocks and when a value other than
zero is specified, it specifies the number of logical data blocks that should be
transferred.
When transfer of multiple data blocks is instructed by this command, when the
data blocks which are to be processed come to a track boundary, cylinder
boundary or zone boundary, a head switch or cylinder switch is executed
automatically and writing of the specified number of blocks is performed.
data blocks which are to be processed come to a track boundary, cylinder
boundary or zone boundary, a head switch or cylinder switch is executed
automatically and writing of the specified number of blocks is performed.
When the specifications in the "Logical block address" field and "Transfer block
count" field in the CDB exceed the maximum logical block address in the HDD,
that command is terminated with a CHECK CONDITION status (ILLEGAL
REQUEST [=5] / Logical block address out of range [=21-00]) and writing of
data to the disk media is not executed.
count" field in the CDB exceed the maximum logical block address in the HDD,
that command is terminated with a CHECK CONDITION status (ILLEGAL
REQUEST [=5] / Logical block address out of range [=21-00]) and writing of
data to the disk media is not executed.
If the write cache function is enabled, the HDD reports a status byte at the point
when reception of all the data transferred from the INIT is completed. If an error
occurs while data are being written to the disk media, a CHECK CONDITION
status is reported for the command to be executed next. If the write cache
function is disabled, a status byte is reported after writing to the disk media of all
the data transferred from the INIT is completed, then execution of the command is
terminated.
when reception of all the data transferred from the INIT is completed. If an error
occurs while data are being written to the disk media, a CHECK CONDITION
status is reported for the command to be executed next. If the write cache
function is disabled, a status byte is reported after writing to the disk media of all
the data transferred from the INIT is completed, then execution of the command is
terminated.