GE GXSL55R Benutzerhandbuch

1. Remove the filter canisters from the manifold by

rotating the canisters to the left about 1/3 turn 
(Fig. 11). NOTE: A small amount of water from the
tubing between the filter and the faucet may come
out. A small towel should be able to catch it.

2. Remove foil on top of new replacement filter

canisters. Install the new canisters into the manifold
by turning to the right about 1/3 turn until the
alignment marks line up and the filter stops. DO
NOT OVERTIGHTEN. The filter will rise up as it 
is turned.

3. Turn handle on faucet to allow trapped air to purge

from the system.

4. Check for water leaks around the system.

5. Once water starts to flow out of the faucet, allow

the system to run for 4 gallons (or 5 minutes) to
flush out any harmless carbon fines that may be
present.

6. Turn off faucet and check around system for leaks.

7. Remove battery tray and replace battery to reset

timer. (See Battery Installation for proper procedure).

FQSLF—Replacement filter canister $30–35
FQSVF—Replacement filter canister $35–40

For replacement parts, call toll-free 800.626.2002
(U.S.), 800.663.6060 (Canada–English), 800.361.3869
(Canada–French).

Whenever water of unknown quality is passed through
the GE Water Filtration system, the filter canisters
should be discarded and the filtration system flushed.

Do not use with water that is

microbiologically unsafe or of unknown quality
without adequate disinfection before or after the
system. Systems certified for cyst reduction may be
used on disinfected water that may contain filterable
cysts.

Circumstances that may require flushing 
the system are:
• Boil water advisory
• Flooding of the GE Water Filtration system
• Long-term non-use

The procedure for flushing the GE Water Filtration
system is:
1. See Replacing the Filter Canisters section and follow

steps 1–5.

To install

To remove