Fujitsu MHT2040AT Benutzerhandbuch

Device Configuration

2-4

C141-E192-01EN

2.2.3 2 drives connection

MHC2032AT
MHC2040AT

(Host adaptor)

Note:

When the drive that is not conformed to ATA is connected to the disk drive above
configuration, the operation is not guaranteed.

Figure 2.3 2 drives configuration

IMPORTANT

HA (host adaptor) consists of address decoder, driver, and receiver.
ATA is an abbreviation of “AT attachment”. The disk drive is
conformed to the ATA-6 interface.
At high speed data transfer (PIO mode 4 or DMA mode 2 U-DMA
mode 5), occurrence of ringing or crosstalk of the signal lines (AT
bus) between the HA and the disk drive may be a great cause of the
obstruction of system reliability. Thus, it is necessary that the
capacitance of the signal lines including the HA and cable does not
exceed the ATA-6 standard, and the cable length between the HA
and the disk drive should be as short as possible.
No need to push the top cover of the disk drive. If the over-power
worked, the cover could be contacted with the spindle motor. Thus,
that could be made it the cause of failure.

MHT2080AT
MHT2060AT
MHT2040AT
MHT2030AT
MHT2020AT