Fujitsu MAG3182FC Benutzerhandbuch
C141-E078-02EN
5 - 4
5.3
Mounting Drives
5.3.1
Mounting procedures
Since mounting the drive depends on the system cabinet structure, determine the work procedures
considering the requirements specific to each system. The general mounting method and items to
be checked are shown below.
considering the requirements specific to each system. The general mounting method and items to
be checked are shown below.
See Subsection 4.1 for the details of requirements for installing the IDD.
1) Fix the drive in the system cabinet with four mounting screws as follows:
•
The drive has 8 mounting holes (both sides: 2
×
2, bottom: 4). Fix the drive by using
four mounting holes of both sides or the bottom. (See Figure 4.5)
•
Use mounting screws whose lengths inside the drive mounting frame are 4 mm or less
when the screws are tightened (see Figure 4.4).
when the screws are tightened (see Figure 4.4).
•
When mounting the drive, be careful not to damage parts on the PCAs.
2)
Check to ensure that the DE is not touching the frame on the system side after tightening the
screws. At least 2.5 mm of clearance is required between the DE and the frame. (Indicated
in Figure 4.4)
in Figure 4.4)
3) When an electric driver is in use, less than low-impact device specifications must be used.