Q-Logic 8200 SERIES Benutzerhandbuch
4 – Using the SANbox SSP
Directly Connecting Devices to SANbox SSP
SN0054628-00 A
4-5
Q
Note the following about
4.3
Directly Connecting Devices to SANbox SSP
SANbox SSP supports the direct connection of its ports to initiator devices. When
directly connecting a device to an SANbox SSP port, make sure that:
directly connecting a device to an SANbox SSP port, make sure that:
■
The device is explicitly configured for loop-only operation (point-to-point is not
supported for directly connecting at this time). See the documentation for your
device for more information.
supported for directly connecting at this time). See the documentation for your
device for more information.
■
if you are attaching a host, the SANbox SSP port mode is set to target or
initiator-target mode. Do not directly connect storage devices or the SVM
appliance to the SANbox SSP.
initiator-target mode. Do not directly connect storage devices or the SVM
appliance to the SANbox SSP.
for details on configuring port modes.
Primary Fabric (FC Switch A)
Secondary Fabric (FC Switch B)
Zone front_A: Primary Initiators
(yellow zone)
Zone front_B: Secondary Initiators
(pink zone)
All primary HBA ports for each host
All secondary HBA ports for each host
SANbox SSP 1, Ports 1-4
SANbox SSP 2, Ports 1-4
Zone back_A: Primary Storage
(green zone)
Zone back_B: Secondary Storage
(orange zone)
All Primary storage ports
All Secondary storage ports
SANbox SSP 1, Ports 5-6
SANbox SSP 1, Ports 7-8
SANbox SSP 2, Ports 5-6
SANbox SSP 2, Ports 7-8
StoreAge SVM Appliances, primary ports
StoreAge SVM Appliances, secondary
ports
ports