Xerox 144 Benutzerhandbuch

Xerox Nuvera

 100/120/144 EA Digital Production System - Customer Expectations Document

 

- 14 -

 

132”  (W) X 29 ” (D) X 61.6 ” (H) 
3353 mm x 737 mm x 1565 mm  

 

125”  (W) X 29 ” (D) X 61.6 ” (H) 

3175 mm x 737 mm x 1565 mm  

Printer Digital Tower 61.6” (1565 mm) (Height)  

DFA finishing devices vary by device*. 

124”  (W) X 29 ” (D) X 61.6 ” (H) 

3150 mm x 737 mm x 1565 mm  

 

31.7”, 805mm 

Optional 

49”, 1233mm 

 

Optional, BFM Plus and Interface Module used with BFM (with top 

tray) in dual BFM installations. 

Fixed:  163” (W) x 112” (D) 
            ( 4140mm x 2839mm) 

Moveable: 163” (W) x 92” (D) 

            ( 4140mm x 2336.8mm) 

- Fixed (stationary) installation: rear of the system should be at least 
30” from the wall, machine, or rear obstruction..  

- Moveable installation: rear of the system should be at least 10” from 

the wall and must be on mobility plates OR hard surface floor AND 

with no more than 4 modules including MFF and MFF Interface 
Module. 

BFM: 145” (W) x 112” (D) 

     3683mm x 2839 mm 
FTM: 143” (W) x 112” (D) 

     3632mm x 2839 mm 

At least 30” from the wall in rear. 

DFA finishing will increase width - FTM config. dimensions do not 
include DFA Finisher(s) dimensions or service space. 

1,753 lb. (795.2 kg) 
Additional SFM – 423 lbs. (192 kg) 

With consumables loaded, except media 

BFM: 1763 lb. (800 kg) 

FTM: 1713 lb. (777 kg) 

Additional SFM – 423 lbs. (192 kg) 

With consumables loaded, except media  

FTM config. listing does not include DFA Finisher(s) weight. 

187 – 240 Volts AC (Nominal), 50 Amp , 

50/60 Hz wall service 

 

Note – FTM and DFA finishers will require 
additional power 

• UL & cUL compliant 

• Complies with the FEMP (Federal Energy Management Program) 

via the machine circuit breaker (CB); with the CB switched off, the 

system consumes less than 1 watt. 

• Energy Star (eStar) compliant** 

• Environmental Choice (Canada)** 

• 

Complies with Section 508 of the ADA Rehabilitation Act

 

187 – 240 Volts AC (Nominal), 30 Amp + 
20 Amp (2) , 50/60 Hz wall service 

 

Feeders and Finisher modules (BFMs) will 

need additional 187 – 240 VAC (Nominal), 
20 Amp, 50/60 Hz wall service 

 

Note – FTM and DFA finishers will require 

additional power 

• Units are compliant with applicable EU directives and are CE 

marked 

* - Please refer to supported inline DFA finishing devices Solution Planning Guides for Product Space and 
Power Requirements. 

** - the following configuration is not Energy Star compliant: 

•  100 ppm printer-only configuration with a BFM