Wyse Technology Z90SW Benutzerhandbuch
2
Installing Z Class RAM
This chapter contains information for users of Wyse Z class thin clients who must install
new RAM.
new RAM.
Requirements
•
Small Phillips screwdriver
Warning
RAM modules may be susceptible to damage by Electro-Static Discharge
(ESD). All industry-standard cautions should be followed to avoid ESD.
Before you remove or install a module, touch any metal part of the chassis
and keep that contact with the chassis during the installation process.
(ESD). All industry-standard cautions should be followed to avoid ESD.
Before you remove or install a module, touch any metal part of the chassis
and keep that contact with the chassis during the installation process.
Procedures
Caution
Follow all precautions listed in the Quick-Start Guide that came with your thin
client for disconnecting and reconnecting the thin client.
client for disconnecting and reconnecting the thin client.
1. Perform a proper shutdown of the thin client by closing all files and ending your
session, and then pressing the power button to turn off the thin client.
2. Unplug the power cord and power adapter, and remove any other cables from the thin
client, and detach the vertical foot.
3. Position the thin client horizontally, where the Wyse logo-side with four flat screws is
facing downward. Using the Phillips Screwdriver remove the two screws from either
end near the back panel, and then remove the three screws from the cover along the
back panel edge, as shown in Figure 1.
end near the back panel, and then remove the three screws from the cover along the
back panel edge, as shown in Figure 1.