HP (Hewlett-Packard) D1B19UARABA Benutzerhandbuch
Power connector cable
NOTE:
The power connector cable spare part kit includes the bracket.
Description
Spare part number
For use only on computer models equipped with an AMD processor and a 90-W AC adapter
681973-001
For use only on computer models equipped with an Intel processor and a 120-W AC adapter
682059-001
For use only on computer models equipped with an Intel processor and a 90-W AC adapter
682058-001
Before removing the power connector cable, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
), and then remove the following components:
a.
b.
Optical drive (see
)
c.
Keyboard (see
d.
Top cover (see
e.
USB board (see
)
f.
Remove the power connector cable:
1.
Remove the Phillips PM2.5×5.5 screw (1) that secures the right edge of the system board to
the base enclosure.
the base enclosure.
2.
Lift the right edge of the system board (2) until the power connector is accessible.
3.
Release the power connector cable (3) from the clips(4) and routing channel built into
the base enclosure.
the base enclosure.
Component replacement procedures
93