HP (Hewlett-Packard) D1B19UARABA Benutzerhandbuch
WLAN module
Description
Spare part number
For use with all computer models:
Atheros 9485GN 802.11b/g/n 1×1 WiFi and 3012 Bluetooth 4.0 Combo Adapter
655795-001
Atheros WB225 802.11b/g/n 1×1 Bluetooth Combo Adapter
675794-001
Broadcom 4313GN 802.11b/g/n 1×1 WiFi and 20702 Bluetooth 4.0 Combo Adapter
657325-001
Intel Centrino Advanced-N 6230 WLAN module
670691-001
Ralink RT5390R 802.11b/g/n 1×1 WiFi Adapter
691415-001
Ralink RT3290LE 802.11b/g/n 1×1 WiFi and Bluetooth 4.0 Combo Adapter
690020-001
Atheros AR9565 802.11b/g/n 1×1 WiFi + Bluetooth 4.0 Combo Adapter for use only on
computer models equipped with an Intel processor
computer models equipped with an Intel processor
690019-001
Intel Centrino Advanced-N 6235 WLAN module for use only on computer models equipped with
an Intel processor in Japan
an Intel processor in Japan
670290-001
CAUTION:
To prevent an unresponsive system, replace the wireless module only with a wireless
module authorized for use in the computer by the governmental agency that regulates wireless devices
in your country or region. If you replace the module and then receive a warning message, remove
the module to restore device functionality, and then contact technical support.
in your country or region. If you replace the module and then receive a warning message, remove
the module to restore device functionality, and then contact technical support.
Before removing the WLAN module, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
5.
Remove the service cover (see
).
Remove the WLAN module:
1.
Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module.
NOTE:
The #1 WLAN antenna cable is connected to the WLAN module “Main” terminal.
The #2 WLAN antenna cable is connected to the WLAN module “Aux” terminal.
2.
Remove the Phillips PM2.0×3.5 screw (2) that secures the WLAN module to the system board.
(The WLAN module tilts up.)
(The WLAN module tilts up.)
Component replacement procedures
57