APC AP7900 Benutzerhandbuch

The installation creates a shortcut link in the 

 menu that you can use to 

launch the Wizard.

Before you run the Wizard, be sure 

that you have the information you will need during the configuration 
procedure:

1. Contact your network administrator to obtain valid TCP/IP settings to 

use.

2. If you are configuring multiple unconfigured Network Management 

Cards, obtain the MAC address of each one so that you can identify 
each Network Management Card that the Wizard discovers. (The 
Wizard displays the MAC address for a discovered card on the same 
screen on which you then enter the TCP/IP settings.)

– For Network Management Cards that you install, the MAC address 

is on a label on the bottom of the card.

– For embedded Network Management Cards, the MAC address is on 

a label on the device containing the card — for example, usually on 
the side of a device that you mount in a rack.

You can also obtain the MAC address from the Quality Assurance slip 
that came with the Network Management Card or with the device 
containing an embedded Network Management Card.