Black Box LPJ008A-F Benutzerhandbuch
724-746-5500 | blackbox.com
Page 32
724-746-5500 | blackbox.com
802.3af and 802.3at PoE Gigabit Injectors
Table A-2 (Continued). SNMP settings.
Item
Default Settings
Description
Trap Hosts
0.0.0.0
Trap hosts are the destination IP addresses that you want the traps to be
0.0.0.0
sent to. You can set the IP addresses in this Controller Setup or by using
0.0.0.0
HyperTerminal.
0.0.0.0
NOTE: The trap notifications are black from entering through the Windows firewall. Configure the Windows firewall settings to
allow incoming network connections by adding a specific program (i.e. the SNMP Console).
If the user is using the Authentication and Privacy passwords, they must remember these to use the Black Box GUI. Open the
Black Box GUI and locate and click the “Setting” button. (See Figure A-10.)
Black Box GUI and locate and click the “Setting” button. (See Figure A-10.)
Figure A-10. GUI connection information.
A pop-up for the User Security Parameters will allow you to enter the correct IP Address of your PoE Gigabit Injector. If the user is
using the Authentication and Privacy Passwords ensure that SNMPv3 is checked and enter in the correct passwords in the spaces
provided. Ensure that the user also matches the name entered in the controller setup.
using the Authentication and Privacy Passwords ensure that SNMPv3 is checked and enter in the correct passwords in the spaces
provided. Ensure that the user also matches the name entered in the controller setup.
Figure A-11. GUI User Security Parameters screen.
If you want to run your SNMP device in Static mode, you can also configure your IP address and subnet mask through the
Ethernet Manager tool (etm.exe).
Ethernet Manager tool (etm.exe).
Click Config—>IP Address
NOTE: From the System Setup menu in the controller, your DHCP client setting must be Disable.