Epson 9840 Benutzerhandbuch

The Model 9840 has three modes of operation, Run mode, Setup mode, and System 
Calibration mode.  At power-on it will be in Run mode. 
 

 

 
 

The first line of the display show an item label (Load A), a value (0.0000), and a unit label 
(Lb). 
 
The second line of the display can show the status of the 4 contact closure limit switches, 
show another display, show text, or be blank.  The above example shows text 
(“INTERFACE MODEL 9840”). 
 
To change what item is being displayed press the leftmost button.  This will cycle through 
the list of items (Load A, Peak A, Vall A, Grs A, Load B, Peak B, Vall B, Grs B,  Ch A+B, 
Pos, Vel, and Limits).  If a torque cell is attached rather than a Load Cell, Torq A or B will 
replace Load A or B.  Channel A+B will only appear when both channels are attached to 
sensors of the same type: load or torque.  
 
The rightmost button will change the units that are being used.  Repeated presses of this 
button will cycle through the list of units available for the currently displayed item.  For 
example, with Load showing you would see Lb, kg, N, PSI, MPa, Klb, kN, t, mV/V, grams, 
and then back to Lb.  Torq will show LbI, NM, OzI and mV/V. 
 
 
 
 
 
 

M O D E L   9 8 4 0                                                                                                                                                          P G   9  

P U B .

2 8 5 6 - 1 6