Epson 9840 Benutzerhandbuch

This section will help you get your Model 9840 set up and operating in just a couple of 
minutes. 

The back panel is shown below.  You will need to make at least two connections here.  
First be sure that the power switch is off (the lower part of the rocker should be pressed 
in).  Connect the AC power line and plug it in. 

 

MODEL 9840 BACK PANEL 

 

 

 

Next connect a load or torque cell to the 9 pin female connector labeled “Load A”.  You 
should use the cabling supplied with your Model 9840 and Interface load or torque  cell.  If 
you do not have a factory supplied cable see Appendix B for the recommended cell 
connection. 

 

You are now ready to turn on the power.  Each time power is applied to the Model 9840 
you will see a sequence of 6 messages appear on the front display.  For example, 

M O D E L   9 8 4 0                                                                                                                                                          P G   6  

P U B .

2 8 5 6 - 1 6