Baracoda Computer Accessories Benutzerhandbuch

BaracodaPencil2 – Programming Guide v1.7

- 12 -

Data Capture

for Workforce

in Motion

1.6/ The different connection methods

There are two (2) different way to create a connection from a Host and a scanner:

Slave mode (by default)

The Host (PC, BaracodaManager, …) is creating the connection onto the scanner.

Master mode

The scanner is creating itself a connection to the recorded Host Bluetooth address. This connection

attempt is set after a scan of barcode. The configuration of Host address (on which the scanner will set

up a connection) can be done:

Via BaracodaManager software.

Via scan of barcodes.

All usage mode (Real Time, No Data Loss, Batch) are obviously available on those two different ways of

connection.

\ V T \ V T Z \ N U L \ S O H \ S O H \ F F \ F F

Enable master mode

\ V T \ V T Z \ N U L \ S O H \ N U L \ F F \ F F

Disable master mode

\ V T \ V T Z \ N U L \ S T X \ S O H \ S O H \ F F \ F F

Enable master mode and disconnect

\ V T \ V T Z \ N U L \ S T X \ N U L \ S O H \ F F \ F F

Disable master mode and disconnect

The configuration of the Host Bluetooth address (BDA) is made by scanning the 0-9, a-f, A-F labels (Appendix 1)

as on a calculator; following the timestamp format shown above.

For example: to set the following BDA: 00:c3:EF:44:a2:B9, the user will scan:

- “Set Remote BDA” label,

- “0” label,

- “c” label,

- “3” label,

- “E” label,

- “F” label,

- “4” label,

- “a” label,

- “2” label,

- “B” label,

- “9” label,

- “End of Config” label.

\ V T \ V T ^ \ N U L \ S O H \ E N Q \ L F \ L F

Set Remote BDA

End of Config