Nortel Networks 311 Benutzerhandbuch
46
Overview
•
4-wire E and M Trunks with:
— Type I or Type II signaling
— Duplex (DX) signaling
•
Paging (PAG) trunks
The trunk type and function can be configured on a per port basis. Dialing
outpulsing is provided on the card. Make and break ratios are defined in
software and downloaded by software commands.
outpulsing is provided on the card. Make and break ratios are defined in
software and downloaded by software commands.
NTCK16 Generic Central Office Trunk card
The NTCK16 generic central office trunk cards support up to eight analog
central office trunks. They can be installed in any IPE slot that supports IPE.
The cards are available with or without the Periodic Pulse Metering (PPM)
feature. The cards are also available in numerous countries.
central office trunks. They can be installed in any IPE slot that supports IPE.
The cards are available with or without the Periodic Pulse Metering (PPM)
feature. The cards are also available in numerous countries.
Installation
This section provides a high-level description of how to install and test
trunk cards.
trunk cards.
IPE trunk cards can be installed in any IPE slot of the NT8D37 IPE module.
shows where an IPE trunk card can be installed in an NT8D37 IPE
module.
When installing trunk cards, these general procedures should be used:
Procedure 1
Installing a trunk card
Step
Action
1
Configure the jumpers and switches on the trunk card (if any) to
meet the system needs.
meet the system needs.
2
Install the trunk card into the selected slot.
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311
01.04
Standard
Release 5.0
23 May 2008
Copyright © 2003-2008, Nortel Networks
.