Soyo SY-P4I845PE Benutzerhandbuch
Hardware Installation
SY-P4I845PE
31
G. CMOS Clear (JP5)
In some cases the CMOS memory may contain wrong data, follow the steps
below to clear the CMOS memory.
In some cases the CMOS memory may contain wrong data, follow the steps
below to clear the CMOS memory.
1. Clear the CMOS memory by momentarily shorting pin 2-3 on jumper JP5.
This jumper can be easily identified by its white colored cap.
2. Then put the jumper back to 1-2 to allow writing of new data into the
CMOS memory.
CMOS
Clearing
Clear CMOS Data
Retain CMOS Data
JP5 Setting
Short pin 2-3 for
at least 5 seconds
to clear the
CMOS
Short pin 1-2 to
retain new
settings
Note: You must unplug the ATX power cable from the ATX power
connector when performing the CMOS Clear operation.
connector when performing the CMOS Clear operation.
Audio Speakers connections
When using 2 channel speaker, connect the speaker cable to line-out.
If you’re using 4 channel speaker, connect the front L/R speakers to line-out
and rear L/R speakers to Line-in. make sure to set the audio software for 4
channel speaker system. Don’t forget to set the Audio Rack software to 4
channel system. Line in is an available in 4 channel speaker mode.
If you’re using 4 channel speaker, connect the front L/R speakers to line-out
and rear L/R speakers to Line-in. make sure to set the audio software for 4
channel speaker system. Don’t forget to set the Audio Rack software to 4
channel system. Line in is an available in 4 channel speaker mode.
1 2 3
1 2 3
Line-out Line-in