Intel DQ57TM Benutzerhandbuch

34 

When you install and test the Intel Desktop Board, observe all warnings and cautions 
in the installation instructions. 

To avoid injury, be careful of: 
•  Sharp pins on connectors 
•  Sharp pins on printed circuit assemblies 
•  Rough edges and sharp corners on the chassis 
•  Hot components (such as processors, voltage regulators, and heat sinks) 
•  Damage to wires that could cause a short circuit 
Observe all warnings and cautions that instruct you to refer computer servicing to 
qualified technical personnel. 

Do not overload the power supply output.  To avoid overloading the power supply, 
make sure that the calculated total current loads of all the modules within the 
computer is less than the output current rating of each of the power supplies output 
circuits plus enough headroom for desktop board power consumption.   

Read and follow the instructions in this section and the instructions supplied with the 
chassis and associated modules.  If you do not follow these instructions and the 
instructions provided by the chassis and module suppliers, you increase your safety 
risk and the possibility of noncompliance with regional laws and regulations.  If the 
instructions for the chassis are inconsistent with these instructions or the instructions 
for associated modules, contact the supplier to find out how you can ensure that your 
computer meets safety and regulatory requirements.   

For information about the Desktop Board’s regulatory compliance, refer to Appendix B.