Intel DQ57TM Benutzerhandbuch

60 

The three-pin BIOS jumper block enables board configuration to be done in the BIOS 
Setup program.  Table 16 shows the jumper settings for the BIOS Setup program 
modes. 

 

Normal (default) (1-2) 

The BIOS uses the current configuration and 
passwords for booting. 

 

Configure (2-3) 

After the Power-On Self-Test (POST) runs, the 
BIOS displays the Maintenance Menu.  Use this 
menu to clear passwords. 

 

Recovery (None) 

The BIOS recovers data in the event of a failed 
BIOS update. 

 

This procedure assumes that the board is installed in the computer and the 
configuration jumper block is set to normal mode. 
1.  Observe the precautions in "Before You Begin" on page 33. 
2.  Turn off all peripheral devices connected to the computer.  Turn off the computer.  

Disconnect the computer’s power cord from the AC power source (wall outlet or 
power adapter). 

3.  Remove the computer cover. 
4.  Find the configuration jumper block (see Figure 27). 
5.  Place the jumper on pins 2-3 as shown below. 

 

6.  Replace the cover, plug in the computer, turn on the computer, and allow it to 

boot. 

7.  The computer starts the Setup program.  Setup displays the Maintenance menu.   
8.  Use the arrow keys to select Clear Passwords.  Press <Enter> and Setup displays a 

pop-up screen requesting that you confirm clearing the password.  Select Yes and 
press <Enter>.  Setup displays the maintenance menu again. 

9.  Press <F10> to save the current values and exit Setup.