Rose electronic CRK-2DFMPD1D/3.2 Benutzerhandbuch

6 

 

CRYSTALVIEW DVI FIBER INSTALLATION AND OPERATIONS MANUAL  

 

Please refer to the safety section first before proceeding with any installation 
or configuration of the CrystalView DVI Fiber. 
 
When installing the CrystalView DVI Fiber, locate the transmitter as close as 
possible to the CPU or switch.  Keep the  cables as short as possible but still 
give some freedom of movement. You can mount the CrystalView DVI Fiber 
in a CPU rack with the optional rack mount kit.  When mounting the units in a 
rack, follow the instructions in Appendix D and Appendix E.  Provide adequate 
air circulation to assure that the maximum operating temperature is not 
exceeded.   
For dual video models, connect a second DVI monitor and additional fiber 
cable from the transmitter to the receiver.  The bottom Fiber connector on the 
Dual video models carries Video 1 and data, top fiber connector carries only 
Video 2. 
 
Wherever the transmitter and receiver units are located, they should be on a 
secure surface and free from obstructions and objects that may cause 
damage to the units.   

 

 

 

Figure 1. Typical cabling configurations 

(See Figure 1 for the connector locations for your model) 

 

NOTE: Using the local access model, a second KVM station can be 
 

connected to the transmitter. 

 

Refer to Figure 1 for the set-up for your system application. 

LOCAL KVM                                       REMOTE KVM
   ACCESS                                                ACCESS 

TRANSMITTER                                             RECEIVER 

Fiber cable 

“Y” PS/2 
Cable