Siemens TX150 S6 Benutzerhandbuch
D2559 (TX150 S6)
Technical Manual
29
4
Replacing the lithium battery
In order to save the system information permanently, a lithium battery is
installed to provide the CMOS-memory with a current. When the charge is too
low or the battery is empty, a corresponding error message is provided. The
lithium battery must then be replaced.
installed to provide the CMOS-memory with a current. When the charge is too
low or the battery is empty, a corresponding error message is provided. The
lithium battery must then be replaced.
V
The lithium battery must be replaced with an identical battery or a battery
type recommended by the manufacturer (CR2032).
type recommended by the manufacturer (CR2032).
Do not throw lithium batteries into the trash can. It must be disposed of
in accordance with local regulations concerning special waste.
in accordance with local regulations concerning special waste.
Make sure that you insert the battery the right way round. The plus pole
must be on the top!
must be on the top!
Figure 10: Replacing the lithium battery
Ê
Press the locking spring into direction of the arrow (1), so that the lithium
battery jumps out of its socket.
battery jumps out of its socket.
Ê
Remove the battery (2).
Ê
Insert a new lithium battery of the same type into the socket (3) and (4).
1
2
3
4