DCS Digital to Digital Converter Benutzerhandbuch
dCS 974 User Manual
Manual for Software Version 1.0x
dCS Ltd
May 2001
Manual part no: DOC1241121A1
Page 43
Document No: OS-MA-A0124-112.1A1
Contact
dCS
on + 44 1799 531 999
email to: more@dcsltd.co.uk
(inside the UK replace + 44 with 0)
web site: www.dcsltd.co.uk
Input Sample Rate
For PCM input modes, the input sample rate can be sensed and set
automatically, using the
automatically, using the
Auto
option, or forced. The latter is useful where use of
1 or 2 wire mode for higher sample rates might be ambiguous – otherwise
Auto
is best. It occurs at the bottom of the
Input Sample Rate
list:
Select the required entry from the list and press
Set
. If you have selected
Auto
,
then the list changes when re-entered:
and the
Status
display will indicate that
Auto
is on:
Output Sample Rate
Output Sample Rate
is a parameter for PCM output modes only. Select the
required
Output Sample Rate
from the list and press
Set
. The dCS 974
accepts 112 input / output sample rate combinations (including DSD) in one
pass. The remaining 70 combinations can be accommodated in 2 passes.
These are shown in
pass. The remaining 70 combinations can be accommodated in 2 passes.
These are shown in
overleaf.
Not all the apparently valid output sample rates may be available to you from
the menu. When
the menu. When
Auto
Input Sample Rate Selection is turned on, the menu
system dynamically alters the
Output Sample Rate
menu to reflect the valid
1 pass output rates for the current input rate. For example, if
Auto
is turned on
and the input is running at 96 kS/s, then the
Output Sample Rate
menu would
look like this: