ASUS P5G41T-M LX PLUS Benutzerhandbuch

Seite von 62
2-12
Chapter 2: BIOS information
2.4.3 
Chipset
The Chipset menu allows you to change the advanced chipset settings. Select an item then 
press <Enter> to display the sub-menu.
North Bridge Configuration
Memory Remap Feature [Enabled]
Allows you to enable or disable the  remapping of overlapped PCI memory above the total 
physical memory. Configuration options: [Disabled] [Enabled]  
Configure DRAM Timing by SPD [Enabled]
Allows you to enable or disable configurating DRAM Timing by SPD. 
Configuration options: [Enabled] [Disabled] 
Initiate Graphic Adapter [PEG/PCI]
Allows you to select the graphics controller as the primary boot device. 
Configuration options: [IGD] [IGD+PEG(Dual)] [PCI/IGD] [PCI/PEG] [PEG/IGD] [PEG/PCI]
IGD Graphics Mode Select [Enabled, 32MB]
Allows you to select the amout of system memory used by the Interanal graphics device. 
Configuration options: [Disabled] [Enabled, 32MB] [Enabled, 48MB] [Enabled, 64MB] 
[Enabled, 128MB] [Enabled, 256MB]
GTT Graphics Memory Size [No VT mode, 2MB]
This item is not user- configurable.
The following item appears only when you installed an Intel
®
 Pentium
®
 4 or later CPU that 
supports the Enhanced Intel SpeedStep
®
 Technology (EIST). 
Intel(R) SpeedStep(TM) Tech [Enabled]
Allows you to use the Enhanced Intel
®
 SpeedStep
®
 Technology. When set to [Enabled], you 
can adjust the system power settings in the operating system to use the EIST feature. Set this 
item to [Disabled] if you DO NOT want to use the EIST.  
Configuration options: [Enabled] [Disabled]
CPU TM Function [Enabled]
Enables or disables Intel
®
 CPU Thermal Monitor (TM) function, a CPU overheating  protection 
function. When enabled, the CPU core frequency and voltage are reduced when the CPU 
overheats. Configuration options: [Disabled] [Enabled]
Execute-Disable Bit Capability [Enabled]
Allows you to enable or disable the No-Execution Page Protection Technology. Setting this 
item to [Disabled] forces the XD feature flag to always return to zero (0).  
Configuration options: [Disabled] [Enabled]