Analog Devices ADSP-21364 Benutzerhandbuch

ADSP-21364 EZ-KIT Lite Evaluation System Manual

1-5 

L

For correct operation, install the software and hardware in the 
order presented in the VisualDSP++ Installation Quick Reference 
Card.

1. Verify that the yellow USB monitor LED (

ZLED3

, located near the 

USB connector) is lit. This signifies that the board is communicat-
ing properly with the host PC and is ready to run VisualDSP++.

2. If you are running VisualDSP++ for the first time, navigate to the 

VisualDSP++ environment via the Start –> Programs menu. The 
main window appears. Note that VisualDSP++ does not connect to 
any session. Skip the rest of this step to step 3.

If you have run VisualDSP++ previously, the last opened session 
appears on the screen. You can override the default behavior and 
force VisualDSP++ to start a new session by pressing and holding 
down the Ctrl key while starting VisualDSP++. Do not release the 
Ctrl key until the Session Wizard appears on the screen. Go to 
step 4.

3. To connect to a new EZ-KIT Lite session, start Session Wizard by 

selecting one of the following.

• From the Session menu, New Session.
• From the Session menu, Session List. Then click New Ses-

sion from the Session List dialog box.

• From the Session menu, Connect to Target. Then click 

New Session from the Session List dialog box.

4. The Select Processor page of the wizard appears on the screen.

Ensure SHARC is selected in Processor family. In Choose a target 
processor, select ADSP-21364. Click Next.