Texas Instruments Avigo Benutzerhandbuch
Avigo Quick Start Guide
5
QUIKSTRT.DOC Chapter 11: Performing Your Calculations Win Jackson Revised: 06/22/98 11:01 AM Printed: 06/22/98 12:56 PM Page 5 of 6
•
Select a component you want to install (Avigo Manager, PUMA IntelliSync
*synchronizer software, Lotus Organizer 97, or Adobe Acrobat), and then follow the
prompts on the setup screens. Select the next component you want to install and
repeat the install process.
Connect Avigo to Your PC
•
Set the Avigo dock station on a flat surface near your PC (Figure 1).
•
Connect the cable connector to the PC serial port you will use. If necessary, use a 9-
pin-to-25-pin adapter. Make sure that all the connectors are connected securely
(Figure 2).
Figure 1: Dock station Setup
Figure 2: Serial Port Connection
•
Position the Avigo over the dock station and slide it gently into the dock station. Make
sure the grooves on the right and left sides of Avigo engage the alignment tracks in the
dock station (Figure 3).
Figure 3: Docking the Avigo
•
Continue sliding Avigo into the dock station until the electronic pins in the dock
station are engaged fully into Avigo.