MASTER LOCK LTR8-512M Benutzerhandbuch
LTRx-512 Installation and User’s Guide
16
3G – Setup Communication
The “factory default” communication settings (LTR8-512 and LTR8-512M only) are:
Baud Rate:
9600
Terminal ID#: 065
Use Function [B] (described on Pg. 30) if you if you need to change these settings for MasterLink
configurations involving multiple Masters,
You can setup your LTR8-512 with LTR MasterLink using RS-232 (serial), RS-485 (networked), Modem
(remote), or Ethernet (requires TXTOSER accessory) Communications.
You must enter these same settings for your LTR8-512 in the LTR MasterLink software
configurations involving multiple Masters,
You can setup your LTR8-512 with LTR MasterLink using RS-232 (serial), RS-485 (networked), Modem
(remote), or Ethernet (requires TXTOSER accessory) Communications.
You must enter these same settings for your LTR8-512 in the LTR MasterLink software
Congratulations! You have finished the basic setup of your LTRx-512 Master.
Basic Setup is Complete!
All of the programmed parameters have been stored in the Master’s protected memory and will be
retained in the event of power failure, brown-outs, etc.
The Master will exit itself out of Program Mode once you stop using the keypad for 5 minutes. If you
wish to exit programming mode immediately, to prevent others from accessing the Master Clock, simply
enter an invalid password. (For example)
Press
retained in the event of power failure, brown-outs, etc.
The Master will exit itself out of Program Mode once you stop using the keypad for 5 minutes. If you
wish to exit programming mode immediately, to prevent others from accessing the Master Clock, simply
enter an invalid password. (For example)
Press
Display
[#]
SELECT FUNCTION CODE
[0]
[0]=ENTER PASSWORD
[#] 99 [#]
PASSWORD: 000099