Acu-Rite CNC 3500i Benutzerhandbuch
ACU-RITE 3500i
163
7.
2
C
a
n
n
e
d
C
y
c
le
s
Field
Code
Description
TPIor Lead
B
Threads per inch (TPI) or lead of thread in
MM. (Required)
NOTE: The minimum number of threads
per inch is "1".
MM. (Required)
NOTE: The minimum number of threads
per inch is "1".
XCenter
X
Absolute X coordinate of the center of the
thread. If no coordinate is entered, the CNC
puts the center of thread at the current tool
position.
thread. If no coordinate is entered, the CNC
puts the center of thread at the current tool
position.
YCenter
Y
Absolute Y coordinate of the center of the
thread. If no coordinate is entered, the CNC
puts the center of thread at the current tool
position.
thread. If no coordinate is entered, the CNC
puts the center of thread at the current tool
position.
ArcInRad
R
Size of radius arcing into start of thread.
NOTE: If R is a positive value or not set and
the thread is "inside", the cycle always
returns to the center between passes.
If R is a negative value, the cutter moves to
the start or end point that is closest to the
center if inside thread, and farthest away
from center if outside thread.
If R is not specified at all and the thread is
outside, the cutter backs away from the
largest diameter by an amount equal to the
thread depth.
NOTE: If R is a positive value or not set and
the thread is "inside", the cycle always
returns to the center between passes.
If R is a negative value, the cutter moves to
the start or end point that is closest to the
center if inside thread, and farthest away
from center if outside thread.
If R is not specified at all and the thread is
outside, the cutter backs away from the
largest diameter by an amount equal to the
thread depth.
StockAmt
S
Amount to leave for a finish pass after the
roughing passes.
roughing passes.
Rough
Feed
Feed
J
Feedrate for roughing. If not set (blank), the
cycle uses the current active feedrate.
cycle uses the current active feedrate.
FinFeed
K
Feedrate for the finish pass. If not set
(blank), the cycle uses the current active
feedrate.
(blank), the cycle uses the current active
feedrate.
Passes
E
Number of roughing cuts to be taken.
NOTE: If Stock is not set or set to zero and
E is 1 or 0, the cycle makes just one pass at
the full depth.
If Stock is set to greater than zero and E is
1 or 0, the cycle makes one pass at the
stock depth and one pass at full thread
depth.
NOTE: If you would like all non-cutting
positioning moves to be rapid, set E to a
negative number.
NOTE: If Stock is not set or set to zero and
E is 1 or 0, the cycle makes just one pass at
the full depth.
If Stock is set to greater than zero and E is
1 or 0, the cycle makes one pass at the
stock depth and one pass at full thread
depth.
NOTE: If you would like all non-cutting
positioning moves to be rapid, set E to a
negative number.