Cisco 2500 IP/FW Plus IPSEC 56 Feature Pack CD25-CHL-12.0= Benutzerhandbuch

14 Release Notes for Cisco IOS Release 12.0(6) Feature Packs for the Cisco 2500 Series

       [Type ?<no> for partition directory; ? for full directory; q to abort]

       Which partition? [default = 1] 2

       System flash directory, partition 2:

       File  Length   Name/status

         1   68       TESTFILE

       [132 bytes used, 4194172 available, 4194304 total]

       Destination file name? c2500-i-l.120-6

       Erase flash device before writing? [confirm] yes

       Flash contains files. Are you sure you want to erase? [confirm] yes

       Copy '' from server

         as 'c2500-i-l.120-6' into Flash WITH erase? [yes/no] yes

       Erasing device... eeeeeeeeeeeeeeee ...erased

       Ready to receive file...........C

       Verifying checksum...  OK (0x5DE8)

       Flash device copy took 00:12:06 [hh:mm:ss]

Installing the Router Software by Using a TFTP Server Application

Use this TFTP server application method as an alternative method to install the router software from
the CD-ROM. You can perform this procedure by using a PC (running Microsoft Windows 95 or
Microsoft Windows 3.1), a Macintosh, or a UNIX system. You can use either the copy tftp flash or
copy rcp flash command to download the router software to the router.

First, obtain a TFTP application or a remote copy protocol (rcp) application to set up your computer
as a TFTP server or an rcp server. If you are using a PC running Windows 95, you can use RSL or
the TFTP server included on the feature pack CD-ROM to install the router software. For other
operating systems, a number of TFTP or rcp applications are available from independent software
vendors or as shareware on the World Wide Web.

To use an rcp application, follow the same procedure below, but substitute “rcp” for

“TFTP”and use the copy rcp flash command instead of the copy tftp flash command.

Install any TFTP server application on the PC. (A PC application is included on the
feature pack CD-ROM for Microsoft Windows 95 only.)

Start the TFTP server application on the PC by double-clicking the application icon or its
.exe filename.

Set up the PC as a TFTP server by using the TFTP server application setup or
configuration facility.

Most TFTP server applications include a setup facility that allows you to specify the PC
as a server. For example, from the TFTP menu of one application, select Settings to
display a panel. To configure the local PC as a server, select the Server checkbox.

Select a root directory where the Cisco IOS files reside (for example,
d:\cpswinst\images).

Make sure you set up your local PC as a TFTP server. If you do not, you cannot perform

the copy procedure. This caution applies to both TFTP and rcp.