Toshiba GD-1320 Benutzerhandbuch

112    Troubleshooting



Below is a list of error codes that you might see in the lists or reports.

If you see an error code not listed here, retry the communication. If this error still occurs, contact your service 
technician or service representative.



Below is a list of error messages that might appear on the touch panel. When any message in the list appears on the touch 
panel, press [FUNCTION CLEAR] on the control panel to clear it, and then take action suggested in the “Remedy” column.

Never attempt to repair, disassemble or modify the equipment by yourself.
You could cause a fire or get an electric shock. Always contact your service representative for maintenance or repair of the 
internal parts of the equipment.

For error messages not listed above and their solutions, refer to the Troubleshooting Guide.

0012

Original misfeed

Clear the misfed original.

0013

Door open

Firmly close the open door.

0020

Power interruption

Check the power interruption report.

0030

Reset

Transmission is cancelled.
(The transmission is terminated by the misfed printing paper during the 
direct transmission.)

0033

Polling Error

Check polling options setup (Security code, etc.), and check if the polling 
document exists.

0042

Memory full

Make sure that there is sufficient memory before making the call again.

0050

Line busy

Retry communications.

0053

Security mismatch in relay or mail 
box transmission

Confirm the remote party’s security code, system password, and your 
setup.

00B0 - 00E8

Communication Error

Retry communications.

Memory overflow

Memory overflowed when scanning documents to 
the memory.

Either wait for memory to be cleared, or check 
the jobs and delete reserved jobs to clear 
memory.

Communication error 

Communication error occurred during direct TX.

Retry communications.

Job reservation full

The number of reserved jobs exceeded the 
maximum.

Either wait for job reservations to be completed, 
or check the jobs and delete reserved jobs.

Job memory full

The total number of destinations for reserved jobs 
exceeded the maximum.

Either wait for job reservations to be completed, 
or check the jobs and delete reserved jobs.

Sorry not possible

On-hook or direct TX was attempted during 
communications.

Wait for communications to end and retry 
communications.

Not allowed now

Further polling transmission reservation was 
attempted even though polling transmission was 
already reserved.

Either wait for polling transmission jobs to be 
completed, or check the jobs and delete reserved 
jobs.

Too Many Tel # Digits

128 digits or more were registered for a chain dial 
communication.

Confirm the number of digits dialed and register 
the numbers again.