Ricoh 2400L Benutzerhandbuch

When the mark made by the verification stamp becomes pale, replace the stamp
as described below.

1. Pull up the scanner.

2. Replace the stamp.

If tweezers are not available, you
may press the point of a pencil down
vertically into the stamp and remove
it by lifting straight up.  

3. Close the operation panel.

1.  Slide out the cassette until it stops. 

Then, with both, remove it by holding it
 up and lifting it out at the same time.

NOTE: Pull it out horizontally.

2. Push down the paper until it clicks into 

place.

3. Take out the  paper.

4. Adjust the paper fences to the paper 

size. To move a fence, pinch the top 
lever in and slide the fence in or out 
as shown. Make sure the positions of
 the two side fences match the paper 
size by checking them against the scale 
printed on the bottom of the cassette. 
The fences should be aligned so that 
the inside edge of each fence is just 
touching the line of the scale.

REPLACING THE STAMP