Ricoh 2000 Benutzerhandbuch
Specifying a Destination
47
1
Specifying a Destination
This section explains how to specify a destination.
Fax numbers, IP-Fax destinations, and e-mail addresses can be specified.
Fax numbers, IP-Fax destinations, and e-mail addresses can be specified.
Note
❒ The display shows the percentage of free memory space for storing originals.
Since fax numbers, IP-Fax destinations and e-mail addresses are programmed
in separate memory, dialing fax numbers using the number keys does not
change the percentage on the display.
in separate memory, dialing fax numbers using the number keys does not
change the percentage on the display.
Sending Over a Fax Line
Enter numbers directly using the number keys on the right side of the control
panel.
panel.
A
Press [
]
to switch the destination to fax number.
B
Enter the fax number using the number keys.
To specify a destination using a Quick Dial key, see “Using the Quick Dial Keys”.
If you make a mistake, press the {Clear/Stop} key, and then enter again.
If you make a mistake, press the {Clear/Stop} key, and then enter again.
C
Press the {Start} key.
The machine starts to scan the original and stores it in memory. When scan-
ning ends, the Communicating indicator lights and transmission starts.
The machine starts to scan the original and stores it in memory. When scan-
ning ends, the Communicating indicator lights and transmission starts.
Note
❒ You can insert pauses and tones in a fax number.
❒ For the maximum number of digits for a destination, see “Maximum Values”.
❒ For the maximum number of digits for a destination, see “Maximum Values”.