Sierra Wireless MP 875 Benutzerhandbuch

Seite von 84
MP875 Modem User Guide
26
 2130808
Connector panel
The MP 875 modem has the following connectors:
Figure 3-2:  MP 875 modem rear connectors
GPS and I/O options
The MP modem provides support for GPS (Global Positioning 
System) and for attaching input/output devices. 
GPS. If you plan to use the MP modem’s built‐in GPS module, 
you must connect a GPS antenna using an antenna cable, or 
use a combination antenna that can connect to both the GPS 
and Main RF connectors on the MP modem housing.
Other I/O devices. Other devices, such as panic buttons, 
sensors, or gauges may also be installed with the MP modem 
and connected with an I/O cable to the I/O port. (See “I/O port 
connections” on page 37.)
Overview of installation steps
Note:  Electrical installations are 
potentially dangerous and 
should be performed by 
personnel thoroughly trained in 
safe electrical wiring procedures 
for vehicles.
The installation process for the MP modem varies depending 
on how you plan to use it, where it best fits, and which of its 
features you plan to use. The main steps are:
1.
Mount the MP modem.
2.
Mount the antennas and connect the cables.
·
Main RF antenna and cable
·
GPS antenna and cable, if you plan to use GPS
·
WAP antenna and cable (MP 595W only)
3.
Connect the power harness. 
I/O connector (DB15HD)
RS-232 serial (female DB9)
USB (Type B)
Ethernet
Power harness (Molex connector)
Main RF antenna (female TNC)
Serial Host
USB Host
GPS
Ethernet Host
I/O
Main RF
Power
AP
 WAP antenna for wireless 
access point
GPS antenna
(female SMA)