Netgear DGN100Bv3 Benutzerhandbuch
NETGEAR genie Basic Settings
32
N150 Wireless ADSL2+ Modem Router DGN1000Bv3
The default setting is 38.
9.
Depending on your configuration, either disable or configure and enable the VLAN:
•
If you do not use interface WAN2 for IPTV service, clear the Use VLANID check box.
The check box might be cleared by default.
•
If you do use interface WAN2 for IPTV service (see the next section,
), configure the following settings:
-
Enter the VLAN ID, as indicated by your ISP.
If you select T-Online as your service provider (see
the default VLAN ID is 7.
-
Select the Use VLANID check box.
If you select T-Online as your service provider (see
this check box is selected by default.
10.
Click the lower Apply button.
The WAN1 interface and PVC settings are saved.
11.
If you do not use interface WAN2 for IPTV service, make sure that interface WAN2 is
disabled:
disabled:
a. From the WAN menu, select WAN2.
b. Clear the Enable This Interface check box.
c. Click the lower Apply button.
Interface WAN2 is disabled.
Configure IPTV Service
The modem router uses interface WAN2 only for Internet protocol television (IPTV) service.
To configure the DLS setup for IPTV service:
1.
Select BASIC > xDSL Setup.
The xDSL screen displays (see the figure on the next page).
The selection from the Physical WAN Type menu is fixed at ADSL2+.
2.
From the DSL Mode menu, select the DSL mode that your ISP provided you:
•
Auto. The modem router detects the DSL mode automatically. This is the default
setting.
•
ADSL (g.dmt).
•
ADSL2.
•
ADSL2+.
3.
Click the upper Apply button.
The DSL mode is saved.