Multitech MT5634ZBA-V-V92 Benutzerhandbuch

                

Chapter 2 – Installation 

Multi-Tech Systems, Inc. MT5634ZBA-Series User Guide (S000286G)                

Plug one end of the serial cable into the RS232 connector on the modem and the other end into a serial port 
connector on your computer, such as COM1 or COM2. 

Plug one end of the modular telephone cable into the modem’s LINE jack and the other end into a standard 
phone wall jack.  

Important: The LINE jack is not interchangeable with the PHONE jack. Do not plug the telephone into the 
LINE jack or the line cable into the PHONE jack.

Note: Regulatory agencies may impose certain restrictions on equipment connected to public telephone 
systems. For more information, see Appendix A.  

Plug one end of a two-wire telephone cable into the modem’s LINE jack and the other end to a two-wire 
leased line wall jack or terminals.  

 Before you can use the modem on a leased line, you must first change the internal jumpers. See “Step 

2: Change the Internal Jumpers.” 

If you want to connect a phone to the same line as the modem, plug it into the modem’s PHONE jack. 

Important: The PHONE jack is not interchangeable with the LINE jack. Do not plug the telephone into the 
LINE jack or the line cable into the PHONE jack. 

For voice mail or speakerphone applications, plug an unamplified microphone into the MIC jack on the side of 
the modem. The microphone should have a stereo 1/8-inch mini plug. Do not use a monophonic microphone

. 

For speakerphone or voice mail applications, use a 1/8-inch mini plug male-to-male stereo patch cord to 
connect the SPKR jack on the side of the modem to the LINE IN jack on your sound card. If your sound card 
does not have a LINE IN jack, use its MIC jack. The stereo male-to-male patch cord can be purchased at a 
local PC retail store. 

If you do not have a sound card, you can plug an unamplified speaker directly into the SPKR jack. 

The power switch is located on the right side of the modem. Make sure it is set to OFF.  

For the global products, plug the universal power supply into the PWR jack on the modem. Then plug one end 
of the country-specific power supply cord into the universal power supply and the other end into a power 
outlet or power strip. 

For Non-global products, plug the power supply lead into the PWR jack on the modem. Plug the transformer 
into a power outlet or power strip.   

Use only the power supply supplied with the modem. Use of any other power supply voids the warranty 

and can damage the modem. 

Test the modem by turning it on. When you turn it on, the modem performs a diagnostic self-test, after which 
the 56 indicator should light. If this does not happen, check that the power switch is on, the power supply is 
solidly connected, and the AC outlet is live. If these measures do not work, see Chapter 7, “Troubleshooting.”