Multitech MT5600ZDXV Benutzerhandbuch

modem. Your modem passes this test if the data entered from the

remote keyboard is the same as the data received on the remote

monitor.

6. When testing is complete, you may end the test by typing an Escape

Sequence  (+++) to bring your modem into Command mode. The

modem should respond with an OK message.

If you wish to stay On-line with the remote modem for normal data

transmission, type ATO0 and hit ENTER. If you wish to terminate the

call, type ATH0 and hit ENTER to hang up.

In this test, your modem must be On-line with another modem set up to

respond to a request for Digital Loopback (note that some modems may

not support Remote Loopback or may have this feature disabled). The

test procedure is as follows:

1. Go into Terminal mode. Type AT and hit ENTER; you should get an OK

message.

2. Dial the remote modem by entering the Dial command and the phone

number, to establish On-line mode. Note:  The &T6 command must be

set on the remote modem to run this test.

3. Type the Escape Sequence (+++) which brings your modem into

Command mode, while still maintaining the connection with the remote

modem.