Multitech MT5634ZBA Benutzerhandbuch

                

Appendix C – Regulatory Compliance 

Multi-Tech Systems, Inc. MT5634ZBA-Series User Guide (S000286G)                

1.  The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted that the 

item complies with minimum conditions for connection to its network. It indicates no endorsement of the product 
by Telecom, nor does it provide any sort of warranty. Above all, it provides no assurance that any item will work 
correctly in all respects with another item of Telepermitted equipment of a different make or model, nor does it 
imply that any product is compatible with all of Telecom’s network services. 

This equipment is not capable under all operating conditions of correct operation at the higher speed which it is 
designated. 33.6 kbps and 56 kbps connections are likely to be restricted to lower bit rates when connected to some 
PSTN implementations. Telecom will accept no responsibility should difficulties arise in such circumstances.  

2.  Immediately disconnect this equipment should it become physically damaged, and arrange for its disposal or 

repair.  

3.  This modem shall not be used in any manner, which could constitute a nuisance to other Telecom customers.  

4.  This device is equipped with pulse dialing, while the Telecom standard is DTMF tone dialing. There is no 

guarantee that Telecom lines will always continue to support pulse dialing.  

Use of pulse dialing, when this equipment is connected to the same line as other equipment, may give rise to 
‘bell tinkle’ or noise and may also cause a false answer condition. Should such problems occur, the user should 
not contact the Telecom Faults Service.  

The preferred method of dialing is to use DTMF tones, as this is faster than pulse (decadic) dialing and is readily 
available on almost all New Zealand telephone exchanges. 

5.  Warning Notice: No ‘111’ or other calls can be made from this device during a mains power failure. 
6.  This equipment may not provide for the effective hand-over of a call to another device connected to the same 

line. 

7.  Some parameters required for compliance with Telecom’s Telepermit requirements are dependent on the 

equipment (PC) associated with this device. The associated equipment shall be set to operate within the 
following limits for compliance with Telecom’s Specifications: 

For repeat calls to the same number: 

• 

There shall be no more than 10 call attempts to the same number within any 30-minute period for any 
single manual call initiation, and 

• 

The equipment shall go on-hook for a period of not less than 30 seconds between the end of one 
attempt and the beginning of the next attempt.  

For automatic calls to different numbers: 

• 

The equipment shall be set to ensure that automatic calls to different numbers are spaced such that 
there is no less than 5 seconds between the end of one call attempt and the beginning of another. 

For automatically answered incoming calls: 

• 

The equipment shall be set to ensure that calls are answered between 3 and 30 seconds of receipt of 
ringing. 

8.  For correct operation, total of the RN’s of all devices connected to a single line at any time should not exceed 5. 

 

This modem must be used in conjunction with an approved surge protection device.