ZyXEL Communications ADSL2+4 Benutzerhandbuch

Chapter 1 Introduction

P-660H-T1v3s User’s Guide

The following table describes the labels in this picture.

Refer to the Quick Start Guide for information on hardware connections. 

If you forget your password or cannot access the web configurator, you will need 
to use the RESET button at the back of the device to reload the factory-default 
configuration file. This means that you will lose all configurations that you had 
previously and the password will be reset to “1234”. You can also use the 

Table 1   LED Descriptions

POWER

Green

On

The P-660H-T1v3s is receiving power and ready 
for use.

Red

On

The P-660H-T1v3s detected an error while self-
testing, or there is a device malfunction.

Off

The P-660H-T1v3s is not receiving power.

ETHERNET
1-4

Green

On

The P-660H-T1v3s has an Ethernet connection 
with a device on the Local Area Network (LAN).

Blinking

The P-660H-T1v3s is sending/receiving data,

Off

The P-660H-T1v3s does not have an Ethernet 
connection with the LAN.

DSL

Green

On

The DSL line is up.

Blinking

The P-660H-T1v3s is initializing the DSL line.

Off

The DSL line is down.

INTERNET

Green

On

The P-660H-T1v3s has an IP connection but no 
traffic.

Your device has a WAN IP address (either static 
or assigned by a DHCP server), PPP negotiation 
was successfully completed (if used) and the 
DSL connection is up.

Blinking

The P-660H-T1v3s is sending or receiving IP 
traffic.

Red

On

The P-660H-T1v3s attempted to make an IP 
connection but failed. Possible causes are no 
response from a DHCP server, no PPPoE 
response, PPPoE authentication failed.

Off

The P-660H-T1v3s does not have an IP 
connection.