SEAL 600-C Benutzerhandbuch

 

 

12

After you are familiar with the control panel and its 
functions, check all operations. 
 

• 

Press the main power stand-by switch UP and the 

Power Indicator Light on the control panel should 
be lit. 

• 

If there is no power, refer to the Troubleshooting 
Page. 

 
 

• 

Press one of the Emergency Stop Buttons and the 
laminator will shut down.  

• 

Rotate the Emergency Stop Button clockwise to 
reset.  

• 

Reset the main power switch (press UP, then 

DOWN). 

• 

Repeat this procedure with both Emergency Stop 

Buttons. 

 

• 

Push the green Motor Switch UP, the switch will be 
illuminated and the rollers should rotate in the 

forward direction.  

• 

As you turn the speed control knob clockwise the 

speed of the roller rotation should increase. 

• 

Turning the speed control knob counter-clockwise 
should decrease the speed of the roller rotation. 

• 

Press the green Motor Switch DOWN and the 
rollers should stop rotating. 

• 

Press the footswitch and the rollers should rotate. 

• 

Turn the speed control knob while using the 

footswitch to verify the speed increases and 
decreases.  

 

Your laminator has pneumatic pressure adjustment with 

fine-tune control for a smooth, flat finish. Correct 
adjustment of the pressure rollers’ height is essential for 

safe and proper operation. Check this prior to every use. 

• 

Press the Roller switch UP. The top roller should 
rise smoothly and evenly on both ends. 

• 

Press the Roller switch DOWN. The top roller 
should lower smoothly and evenly on both ends. 
IMPORTANT: The silicone covering of the 
rollers is soft. Do not scratch the surface with a