SEAL 600-C Benutzerhandbuch

 

 

17

The following are the basic webbing procedures for 
webbing films with a release liner. It is important to 

follow the webbing instructions for films specific for 
your location. 
 

• 

Select films slightly wider than the image to allow 
for a border without film waste. A border of 1/8” 

to 1/4” (3 - 6mm) is adequate. 

• 

Load and center the films on top and bottom 

unwind shafts with the dull adhesive side facing out 
and the unwind brake tension released.  
NOTE! Check if the film widths of the lower 
and upper web are the same! 

• 

Remove the front table for easier webbing access. 

• 

Remove the Wind-up Idler and place a spare core 

over it and insert back into place. 

• 

Apply either double stick tape or a strip of the 

pressure-sensitive mounting adhesive film across 
the width of the spare core and remove the backing.  

• 

TOP FILM: (film with a release liner) Pull the film 
forward off the top unwind shaft and adhere the 
release liner (facing up) smoothly to the adhesive on 

the core. Take care to ensure that the release liner is 
pulled square with the roll of film and that no 

diagonal wrinkles are apparent.  

• 

Separate the film from the release liner secured to 

the core and pulling the film squarely downward, 
adhere it to the film draped over the face of the 

bottom roller.  
TIP: Using a piece of tape will assist with this 

• 

BOTTOM FILM: Pull the film up from the bottom 
unwind shaft and place it evenly over the top film 

across the face of the top roller.  

• 

Set the Shim Wheels to 1/16” (2mm) to allow for 

the thickness of a leader-board. 

• 

FILMS INTO NIP: Use the leader-board to push 
the film(s) into the main roller nip. 

• 

Lower the top roller and return the in-feed table to 

its working position. 
NOTE! Keep the film under tension (holding 

• 

Using the foot switch, advance the leader board 
through the nip. 

• 

Release the footswitch, raise the top roller and set 
the Shim Wheels to ‘0’, then lower the roller again. 

• 

Moving to the rear of the laminator, with the film 
and leader board hanging over the rear table, cut off 

the leader board.  

• 

Return to the front of the laminator and using the 
footswitch, apply light unwind brake tension 

gradually on both unw ind shafts until there are no 
wrinkles in the film as it goes into the nip  
NOTE! Best results will be obtained when the 
film unwind tension is zero or very light. 

• 

Run the laminator for about 3 feet (1 meter), to 
work out any wrinkles. If wrinkles persist, cut the 

film and web the laminator again. 

Pressure-Sensitive Over-Laminate

Pressure-Sensitive Mounting Adhesive

Release Liner