SEAL 600-C Benutzerhandbuch

P R E - C O A T I N G B O A R D S

This process is used to coat substrates with a self-
adhesive coating onto which images can be mounted.

Images can then be mounted on the substrate. This
same process is used to create a Sled (refer to Glossary).

LAMINATOR SETTINGS:

FRONT CONTROL PANEL

Main Roller Pressure:

35-40 PSI

Motor Speed Setting:

3-5 FPM (1-1.5 MPM)

WEBBING SETTINGS

Web Tension Top:

Medium

Web Tension Bottom:

Shim Wheel Setting:

Substrate determined

IMPORTANT! Ensure that the Shim Wheel
settings of the rollers correspond to the board

thickness.

WEBBING PROCEDURE

•

Load the roll of pressure sensitive adhesive onto the

top unwind shaft of the laminator with the exposed
adhesive facing you.

•

Use a leader-board of the same thickness as the
boards to be coated.

•

Pull the adhesive down from the top unwind shaft
and place evenly across the face of both rollers.

•

Press the foot switch and using the leader -board,
push the adhesive into the roller nip

•

Release the foot switch when the rear edge of the

leader-board is almost leaving the roller nip.

•

Position the board to be coated into the nip, behind

the leader board and choose a speed setting.

•

Press the motor switch ON or use the footswitch to

process the board.

NOTE: When coating boards, ensure that the next
board to be coated follows the previous board

without any gaps.

NOTE: Follow the last board being coated with
another leader-board again to allow the final board

to clear the laminating rollers and then stop the
motor and raise the top roller.

U n w i n d

S h a f t

TOP
ROLLER

BOTTOM
ROLLER

Wind-Up

Idler

Pressure-sensitive mounting adhesive

Sled

U n w i n d
S h a f t

Release Liner

Figure 14. Pre-Coating Boards for North America